Reeling it In: How to Wind Fishing Line on a Reel Like a Pro

How to Wind Fishing Line on a Reel: A Step-by-Step Guide

Introduction

Fishing is one of the most popular recreational activities enjoyed by people around the world. Whether you are an experienced angler or just starting out, knowing how to properly wind fishing line onto your reel is crucial for successful and enjoyable fishing trips. In this guide, we will walk you through each step, ensuring that you have a well-wound reel and avoid any potential frustrations during your next fishing adventure.

Gather Your Supplies

Before you start winding the fishing line onto your reel, make sure you have all the necessary supplies handy:

1. Fishing line – Choose a high-quality monofilament or braided line suitable for your specific fishing needs.

2. Reel – Ensure that your reel is clean and in good working condition before proceeding with winding the line.

3. Scissors or clippers – You’ll need these to trim excess line later in the process.

Selecting the Right Line Capacity

When choosing a fishing line for your reel, it’s important to consider its capacity. Refer to both your reel’s instruction manual and its spool markings to determine its appropriate line weight range (e.g., 10-20 lb). Make sure not to exceed this limit as it may cause casting problems or even damage your gear.

Attach the Backing Line (Optional)

If desired, attaching backing can increase overall line capacity and prevent slippage between the spool arbor and mainline knot. Here’s how:

1. Securely tie one end of the backing onto the spool arbor using an Arbor Knot.

2. Slowly wind it tightly around until there’s approximately 1/8 inch space left from reaching the edge of spool rim.

4. Tie the backing to the mainline with a Uni Knot or any other preferred knot.

Stringing the Mainline

Now that you’ve prepared your reel, it’s time to string the main fishing line onto it:

1. Open the bail arm (for spinning reels) or remove spool side plate (for baitcasting reels).

2. Pass the end of your fishing line through rod guides up to tip guide, leaving a 6-8 inch tag end for later use.

3. Insert this tag end securely into your reel’s spool arbor by tying an Arbor Knot.

4. Slowly turn the reel handle clockwise while applying slight tension on the line coming from rod tip using fingers of your free hand.

5. Continue winding until approximately 1/8 inch space is left from filling up the entire spool rim, ensuring that lines are evenly spread without overlapping or crossing over each other.

Trimming and Finishing Touches

Once you have successfully wound your fishing line onto the reel, follow these final steps for a neat finish:

1. Trim off any excess line using scissors or clippers, leaving about 1/8 inch extending past spool rim edge.

2. Close and secure either bail arm (for spinning reels) or replace side plate (for baitcasting reels).

3. Give your newly wound fishing line a gentle tug to check if everything is properly secured and there are no loose knots.

4. Congratulations! You have now successfully wound your fishing line onto your reel!

Conclusion

Properly winding fishing line onto a reel not only ensures hassle-free casting but also improves overall performance during angling adventures. By following our step-by-step guide, you can easily wind Fishing Line on Reel like a pro! Remember always to consider factors such as appropriate capacity and type of knot used when preparing for various fishing scenarios. So, get out there and enjoy the thrill of fishing with confidence!